denverpaster.blogg.se

Ultimate usb loader gx forwarder channel version 5.1
Ultimate usb loader gx forwarder channel version 5.1











ultimate usb loader gx forwarder channel version 5.1

Not sure what I can do, if it is the hdds fault and I need to buy a new, though I might get another one that doesn't work. I exited to the hbc, ran SysCheck and started USB Loader again, it is much faster at the Initialize USB Device, and now I can enable Wii games. With this the loader starts fine it (a delay of say 5 sec at initializing usb device), when started up it says USB Device not initialized, switching to channel list mode and I can't enable Wii games. I manually (sorry about that) edited meta.xml and changed the Usb Port from 1 to 0 to match the setting in the loader, ios is 58 and automount is 1. Tried a cold restart, firing up SysCheck and then when it was done starting USB Loader which starts up fine, but enabling Wii games gave the same error about USB Device not initialized. It loads up without freezing, but when I select titles sources and enable Wii games it says: "Error: USB Device not initialized.

ultimate usb loader gx forwarder channel version 5.1

Ultimate usb loader gx forwarder channel version 5.1 full#

I exited, did a full shutdown, connected the WD hdd and turned power on. I have started the loader without the hdd connected to change the setting for LoaderCIOS to IOS 58, Game's IOS is 249. I think the problem is the drives might require more time to initialize properly, and using or switching back to cIOS too soon might be problematic. If you launch a gamecube game, it'll keep IOS58 and no re-init is needed. it might fail here if you use a flash drive, because flash drives are not working with cIOS, but should work with WD HDDs. The IOS switch will be done only if needed = at wii game launch using the "game's IOS" setting usually set to 249. it will automatically edit the meta.xml to reflect the IOS you chose so both the meta.xml (use to boot the loader) and the loader's IOS (used inside the loader) are identical to prevent the need to switch the IOS and re-initialize the USB. Usually, you don't edit the meta.xml or config file manually, but change the loader's IOS from the internal loader's interface. Using IOS58 is a solution to initialize the HDD.īut you should keep IOS58 for "laoder's IOS" setting too, so it doesn't reinitialize, it keeps IOS58 once into the loader. I'm ready to do some experimenting if you have any ideas. I hope with all my heart for help to get this resolved. If I do a cold boot and start USB Loader GX without doing anything (either from HBC or from a forwarder) it freezes at reinitializing devices. I can see all GC and WII applicaitons and start them. Now it get past the initialize usb device, but freezes at reinitializing devices.īut if I run SysCheck first I can right after start USB Loader GX and it works without freezing. Well I also tried a 2TB WD Green something in an external hard drive cabinet and that worked only if I connected it when the loader starts waiting for USB HDD. VIOS251 (rev 21010, Info: d2x-v10beta52-vWii): NAND Access, USB 2.0Īt some point I had it to work if I didn't connect the USB HDD (WD My Book Essentials 2TB MBR, FAT32) untill it waits 20 sec for USB HDD. SysCheck HDE v2.4.0 HacksDen Edition by JoostinOnline, Double_A, R2-D2199, and Nanoįound 34 IOS on this console.













Ultimate usb loader gx forwarder channel version 5.1